1
531655-1_A
1100 Series™ In-Dash Mounting Kit
Thank You
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its
reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment.
Genuine Humminbird® accessories offer the opportunity to upgrade and expand the capabilities
of your Humminbird® product.
Your Humminbird® is designed for trouble-free use in even the harshest marine environment. In
the unlikely event that your Humminbird® does require repairs, we offer an exclusive Service
Policy - free of charge during the first year after purchase, and available at a reasonable rate after
the one-year period. For complete details, see the Warranty section included in this manual.
Contact our Customer Resource Center at either 1-800-633-1468 or visit our website at
Installation Overview
Following are instructions for the installation of this accessory. Before you start installation, we
encourage you to read these instructions carefully in order to get the full benefit from your
Humminbird® accessory.
If you find that any items are missing from your installation kit, call our Customer Resource Center
Installation
Start by placing the components on the surfaces where you intend to install them before
installation. Make sure that the surfaces you have chosen provide adequate protection from
wave shock, and that all cables can reach the control head.
NOTE: If a cable is too short for your application, extension cables are available.
Call Humminbird® Customer Support at 1-800-633-1468 for more information.
Parts and tools specific to In-dash mounting are:
• Threaded rods and hardware
• In-dash mounting foam pads
• In-dash mounting template
• Reciprocating saw for cutting dash material
• Masking tape to hold mounting template in place.
1. Locate a suitable, flat area of the dash to mount the control head. The control head
requires a depth of at least 4 inches (102 mm).
Mounting the Control Head
Foam Pads
Threaded Rod
Washer
2. Tape the paper In-Dash Mounting template to the desired in-dash mounting location.
3. At a location inside the dotted line on the template, drill a hole large enough to insert
blade of reciprocating saw. In addition, drill the 4 mounting hole locations using a 3/16"
drill bit. Carefully begin cutting toward the dotted line, then follow the dotted line
around the template. Remove the template when finished.
Cut
Away
Dash
Wing Nut
Lock Washer
4. Insert and tighten the four threaded rods into the four threaded inserts located on the
back side of the control head. Peel off the adhesive-backed foam pads and place them
on the back of the control head; make sure you notice the difference between the
longer top/bottom and shorter side pads.
Foam Pads
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
3
531655-1_A
1100 Series™ In-Dash Mounting Kit
1-Year Limited Warranty
Humminbird® Service Policy
We warrant the original retail purchaser that products made by
Humminbird® have been manufactured free from defects in materials
and workmanship. This warranty is effective for one year from the date
of original retail purchase. Humminbird® products found to be defective
and covered by this warranty will be replaced or repaired free of charge
at Humminbird® option and returned to the customer freight prepaid.
Humminbird® sole responsibility under this warranty is limited to the
repair or replacement of a product that has been deemed defective by
Humminbird®. Humminbird® is not responsible for charges connected
with the removal of such product or reinstallation of replaced or
repaired parts.
Even though you'll probably never need to take advantage of our
incredible service policy, it's good to know that we back our products
this confidently. We do it because you deserve the best. We will make
every effort to repair your unit within three business days from the
receipt of your unit at our factory. This does not include shipping time to
and from our factory. Units received on Friday are typically shipped by
the following Wednesday, units received Monday are typically shipped
by Thursday, etc.
All repair work is performed by factory-trained technicians to meet
exacting factory specifications. Factory-serviced units go through the
same rigorous testing and quality control inspections as new
production units.
This warranty does not apply to a product that has been:
• Improperly installed;
After the original warranty period, a standard flat rate service charge
will be assessed for each repair (physical damage and missing parts are
not included). Any repairs made after the original warranty will be
warranted for an additional 90 days after service has been performed
by our factory technicians. You can contact our Customer Resource
Center or visit our website to verify the flat rate repair fee for your
product (visit the Product Support section):
• Used in an installation other than that recommended in the
product installation and operation instructions;
• Damaged or has failed because of an accident or abnormal
operation;
• Repaired or modified by entities other than Humminbird®.
Please retain your original receipt as a proof of the purchase date. This
will be required for in-warranty service.
We reserve the right to deem any product unserviceable when
replacement parts are no longer available or impossible to obtain. This
Service Policy is valid in the United States only. This applies only to
Humminbird® products returned to our factory in Eufaula, Alabama.
This Service Policy is subject to change without notice.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES,
OBLIGATIONS OR LIABILITIES ON THE PART OF HUMMINBIRD® AND
WILL BE THE CUSTOMER'S EXCLUSIVE REMEDY, EXCEPT FOR ANY
APPLICABLE IMPLIED WARRANTIES UNDER STATE LAW WHICH ARE
HEREBY LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF
ORIGINAL PURCHASE. IN NO EVENT WILL HUMMINBIRD® BE LIABLE
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH
OF ANY EXPRESS OR IMPLIED WARRANTY RELATING TO THE
PRODUCTS.
Some states do not allow limitations on an implied warranty, or the
exclusion of incidental or consequential damages, so the above
exclusions may not apply to you. You may also have other rights, which
vary from state to state.
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
4
531655-1_A
1100 Series™ In-Dash Mounting Kit
Returning Your Unit for Service
Contact Humminbird®
Before sending your unit in for repair, please contact the factory, either
by phone or by email, to obtain a Repair Authorization Number for your
unit. Please have your product model name and serial number
available before calling the factory. If you contact the factory by e-mail,
please include your product model name and serial number in the e-
mail, and use Request for Repair Authorization Number for your e-mail
subject header. You should include your Repair Authorization Number in
all subsequent communications about your unit.
Contact the Humminbird® Customer Resource Center
in any of the following ways:
By Telephone
(Monday - Friday 8:00 a.m. to 4:30 p.m. Central Standard Time):
1-800-633-1468
By e-mail
For IN-WARRANTY service, complete the following steps:
(typically we respond to your e-mail within three business days):
• Obtain a Repair Authorization Number from the Humminbird®
Customer Resource Center.
For direct shipping, our address is:
• Tag product with your name, street address, phone number and
your assigned Repair Authorization Number.
Humminbird
• Include a brief written description of the problem.
Service Department
678 Humminbird Lane
Eufaula, AL 36027 USA
• Include a copy of your receipt (to show proof and date of purchase).
• Return product freight prepaid to Humminbird®, using an insured
carrier with delivery confirmation.
WARNING! Do not touch an active transducer during operation, as this
may cause physical discomfort and may result in personal injury in the
form of tissue damage. Handle the transducer only when the power to
the control head is off.
For OUT-OF-WARRANTY service, complete the following steps:
• Obtain a Repair Authorization Number from the Humminbird®
Customer Resource Center.
WARNING! This device should not be used as a navigational aid to
prevent collision, grounding, boat damage, or personal injury. When the
boat is moving, water depth may change too quickly to allow time for you
to react. Always operate the boat at very slow speeds if you suspect
shallow water or submerged objects.
• Include payment in the form of credit card number and expiration
date, money order or personal check. Please do not send cash.
• Tag product with your name, street address, phone number and
your assigned Repair Authorization Number.
WARNING! Disassembly and repair of this electronic unit should
only be performed by authorized service personnel. Any modification
of the serial number or attempt to repair the original equipment or
accessories by unauthorized individuals will void the warranty.
Handling and/or opening this unit may result in exposure to lead, in
the form of solder.
• Include a brief written description of the problem.
• Return product freight prepaid to Humminbird®, using an insured
carrier with delivery confirmation.
WARNING! This product contains lead, a chemical known to the
state of California to cause cancer, birth defects and other
reproductive harm.
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
|